110 Acribond 1.0L Tin Thick Cast Acrylic (Class 3)

Contains

U.N. 1193 METHYL ETHYL KETONE CAS No. 78-93-3
and ACRYLIC RESIN 
PG II
HAZCHEM CODE 2 (Y) E
Class 3

Instructions

Parts to be joined should fit without forcing and be clean. Apply adhesive with suitable applicator and assemble while parts are still wet. Press parts together in firm contact. ACRI-BOND 110 forms initial bond very quickly. Strength develops rapidly reaching full strength in 24 to 48 hours leaving about 30% dry residue. This acrylic cement has a limited gap filling ability.

Recommended use

This adhesive has been design for bonding Acrylic to Acrylic. Also, shows good results bonding Acrylic to Polycarbonate, HIPS, ABS, PVC and those materials to itself. Test before use for other combinations.

Warranty

This product is intended for use by skilled individuals at their own risk. Since specific use, materials and handling are not controlled by ATA, our warranty is limited to the replacement of defective products only.

Risk - R11, 36/37, 66, 67

Highly flammable. Irritating to eyes and respiratory system. Repeated exposure may cause skin dryness and cracking. Vapour may cause drowsiness and dizziness.

Safety - S9, 16, 23/25/26, 33, 36/37/39

Keep container in a well ventilated place. Keep away from sources of ignition – No smoking. Avoid contact with eyes. Take precautionary measures against static discharges.

First Aid

If swallowed, do NOT induce vomiting. Give a glass of water. If in eyes, hold eyes open, food with water for at least 15 minutes and see a doctor. If skin contact occurs, soak contaminated clothing with water and then remove. Wash skin with soap and water. If inhaled, remove from contaminated area. For advice contact a Poisons Information Centre in Australia 131 126 or a doctor.

Spills/leaks

Don protective equipment. Remove sources of ignition. Stop leak if safe to do so. Contain spilled material, absorb on sand or earth and place in properly labelled sealed containers for disposal. Eliminate all sources of ignition – no smoking.

Fire

Use foam, dry chemical or carbon dioxide to fight fire. Cool tank/container with water spray.

ADDITIONAL INFORMATION IS LISTED IN THE MATERIAL SAFETY DATA SHEET