ClipGlaze 3mm Prepack 15m Kit Brown
larger imageMove mouse over the image to magnify
 

DGP50B

DGP50B

ClipGlaze 3mm Prepack 15m Kit Brown

NZ $73.60
excl GST
Qty.

ClipGlaze double glazing comprises a flexible PVC edging strip, which is placed neatly
around a piece of plastic sheet and held in position by nylon fixing clips and
woodscrews. A mitre gauge to help cut neat accurate corners is available,
 
ClipGlaze double glazing pre-packs are an alternative to the loose packed items
mentioned so far. A 15m kit in any of the edging strip sizes or colours, comes
complete with 72 clips and 72 screws to fix the edging strip provided. A mitre gauge
and full fitting instructions are included in the pre-pack.

dgpic01w
A ClipGlaze secondary pane can be fixed either to the opening window lights to
allow ventilation and use of the windows, or to the main frame for maximum
insulation and draught proofing. When use of the windows is required, we suggest
the glass is installed externally. Where possible, allow the secondary glass to overlap
the frame by 10mm on each edge.

 


Measuring up for your glass or sheeting

1. Place a mark on the edging strip 5cm from a neat squarely cut end.
2. Lay the edging strip in the channel of the ClipGlaze mitre gauge so the mark on the edging strip is in the
centre of the middle "V". Holding the strip firmly in
the two finger grips, cut down each side of the "V"
with the sharp knife, being careful not to cut right
through the strip.
MitreGauge

3. Now carefully fit the edging strip on the glass, the cut out should mould easily
around the first corner. Continue along this edge to the next corner and place a
mark with the pen on the edging strip where the glass finishes. This point marks
the position of the next corner.
4. Repeat steps 2 and 3 until the edging strip is fitted around the pane of glass.
5. You will need a clip about 5cm from each corner on each side, then clips spaced
equally about 20-25cm along the remaining distance.
6. Position the sheet carefully so there is an equal overlap on the frame on all four
sides.
7. Fix the two clips on the bottom edge 5cm from the corners - these will hold the
weight of the sheet.
8. Make sure the glass is clean and the window perfectly dry before resting the
pane on the bottom fixing clips. Fix two clips on the top edge, making sure that
one of these first four clips covers the join in the edging strip.
9. Now complete the window by fixing the rest of the clips as suggested above.

You might also be interested in ...

ClipGlaze Mitre Gauge
NZ $1.35
excl GST

EMAIL UPDATES

Sign up to our quarterly newsletter, enter your email below. Learn more
Email*
 
EXTREMELY HAPPY WITH THE END PRODUCT. IT IS MADE VERY PROFESSIONALLY AND IS EXACTLY WHAT WE WERE LOOKING FOR
Nathan, Christchurch